What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 29.06.2025 00:50
An AC voltage/ current source, and an ac inductive load.
Here is a simplified AC power diagram.
I post the exact comment here.
End of an era: Space Launch Complex 37 gets demolished - Spectrum News 13
First Sentence:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These are simplified answers to the original question, and does not change anything I wrote above.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
In schematic diagrams this is the symbol for a fuse:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
(Dc diagram shown, AC is similar).
eight
What is the one thing you don't understand that others do?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
One is “what exactly is in a ‘surge protector’ ? ”
These devices are installed between the “hot” and “neutral” and protective ground.
There are two important concepts here.
The other is “what does a “fuse” do?”
Most-complete Stegosaur skull ever found forces rewrite of dinosaur history - Earth.com
At one ohm, the resistor has a maximum of 1 watt power.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
The bolt then partially travels down the line to your home.
Because the load is inductive, the current lags the voltage.(by a bit).
so, what happens?
What is the problem between Turkey and Greece?
the problem then depends on "how fast does the fuse operate?".
[old diagram got deleted by accident]
For this case there are devices called Metal oxide varistors (MOV).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
He then describes the function of a fuse.
PSA: You Probably Don't Need To Be Weighed At The Doctor's Office - HuffPost
The third is lightning and “how it gets conducted into a home.”
It seems Mohan does not understand the difference between a comment and an Answer.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
How will artificial intelligence impact employment and the job market?
[image of Common-mode choke]
He then describes Rainy Season and Lightning.
This is 'the assistant's answer'
At least they know the answer if they wanted it.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
but this device (an Inductor) … impedes the rapid changes in the current.
a photo is worth a thousand words.
Now when you have a certain ac resistance, then a current flows in a loop.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
A fuse is a non-resetable over current circuit protector.
2024–10–10[John johnson John Johnson ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But it can get overloaded, and no longer works.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
what exactly is a ‘surge’ protector?
Barnstars:
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
What is lightning?
nine
This one hit behind the barn.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
One
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–16 [ OO OLAOYE OYEBODE ]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
He then asserts :
2024–10–14 [Omar Gharbi Omar Gharbi ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
It also is a device that limits the change in current flow.
Upvotes:
The MOV will conduct when the voltage exceeds 50% of line voltage.
This device then solves the entire problem.
Edit 2024–10.
But… the neutral is now “floating” because of the 1 ohm resistance.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
A circuit breaker is similar, but is resettable.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What does a fuse do?
There are three different concepts here that are getting confused.
but I think this circuit , shows a few more pieces.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.